Snap-Fit Cable Dragon

Modification, remixing, and commercial use of this data are strictly prohibited. If you wish to sell prints, please obtain a commercial license from here https://www.patreon.com/cw/Manabun_lab A tiny dragon that clips onto your cable or Bowden tube, one piece at a time. No glue, no supports needed.   Unlike single-piece "flexi" dragons, this one is built from separate parts — head, body, and tail — that snap onto the cable individually. Print as many body pieces as you need to adjust it to your preferred length.   Boost MeEnjoyed printing this? A boost helps a lot — thank you!Fits: Ø2.5–3mm cables (phone chargers, earbuds case cords, slim USB-C/Lightning cables) Ø3.5–4mm cables & tubing (fast-charge cables, USB hubs,Bowden tubes) Print notes: No supports needed The 3mf ships with 6 body segments by default — duplicate the body piece as many times as you like to extend the dragon to match your cable's length Great for AMS / multicolor printing Assembly: snap the segments onto the cable in order, starting from the head   Assembly: 1. Start with the head. Snap the C-shaped clip onto the cable — it should feel snug, even a little tight; that's the best fit.   2. Snap the lower jaw closed.   3. Fit the left and right legs into the round holes. Make 2 of these sets.   4. Referring to the photos, snap on the remaining clips one by one to finish.   5.Print a bunch of body pieces and build your own extra-long dragon!