The Keepers of Kord - DnD Miniature Pack

The Keepers of Kord - A themed group of adventurers and followers of Kord   Scaled for 32mm gaming, with base they may be a few mm over, measured from table to head. Weapons might stand slightly above that, depending on model. These are mostly available as a .2mm nozzle release. I will continue to work on a version for .4mm nozzle but the delicate nature and small details may prove challenging. The supports are easy, but be patient and take your time. The .2mm supports are paper thin and will come away with little effort. Use tools like a flush cutter and razor where needed. ***I want to add that I do NOT recommend Matte Filament for .2mm miniature profiles. Not only is Matte filament more likely to cause a clog but I have found it to be far more brittle and stiff. It will break instead of bend or flex. Because of this you are more likely to snap a small detail while removing supports using Matte filament.***   The models have fine, thin details like swords and whips. I was able to remove supports cleanly but with care. These small details are delicate and will require care when handling, removing supports, and painting.    As shown printed in Sunlu High Speeds PLA + 2.0 No paint or Primer has been used, the models will looks like this post support removal.    Boost MeIf you appreciate the models and want to boost, it is greatly appreciated!