Angled Cuffs - (B.D.S.M.)

This is in the first piece of a fully 3d printed Bondage System that I am calling Bondage Device System, Modular (B.D.S.M.). Read below for future plans.   Fully 3d printed set of cuffs with tapered inner profile. To pick the right size, measure the width of the wrist at the wrist bone. And add 10mm then pick the closest cuff size. Start by printing one and testing to make sure it's not too tight. Restricting blood flow isn't something you want to play with.  Large Cuff WidthSmall Cuff Width50mm37.5mm55mm41.25mm60mm45mm65mm48.75mm70mm52.5mm75mm56.25mm80mm60mm  The threads might be a bit tight the first few times, just run them back and forth to break them in.   What to Print   For a complete set of cuffs, you will need to print Angled Bar - 1x Wedge Bolt- 2x Wedge Nut - 2x Cuffs - 2x sets   Assembly Remove all support Before putting anything together, run the cuff bolts in and out of the threaded part of the bolt a few times to break the threads in. like wise, run the wedge nut and bolt together a few times.        Troubling shooting The threads might be a bit tight the first few times, just run them back and forth to break them in.     Future plans for the system: If you have any ideas for parts for the system or why to make the system better please leave a comment or send me a message.  Currently being testedStraight bars from 50-300mm for:Spreader bar straight cuffs Pillory Whatever you mind can dream Oval Ankle Cuffs Round Ankle, Wrist, and neck cuffs Joint pieces in Square, T-shaped, and triangle shaped, plus more Other ideasbelt or wast cuff rope attachment points screw attachment points for wall or bed frame friction push pins for quicker use than the threaded cuff bolt An ice timer module to add between the bar and the cuff.A safety block (quick release, or breakable part) to be used with the ice timer for self-bondage. Anything the community suggests.    Disclaimer: You take full responsibility for the safe use of these devices. To have to make sure they are not restricting blood flow. The filament and print settings used will determine how strong they are.  These are not designed for weight baring. For use by consenting adults only.      Boost MeIf you had fun with the model, consider leaving a boost.