Sleepy Baby Cat

Important! The model is very small. It is critical to clean the print bed beforehand. A little cat that found the perfect place for a nap. This model is designed to rest over the edge of your printer, with its paws and tail hanging down naturally. I wanted to keep the pose relaxed and give the cat enough sculpted detail to look good up close without losing the simple, cozy feel of the model. It looks especially nice sitting on top of a Bambu Lab printer, but it should work just as well on shelves, monitors, cabinets, or any similar edge. A small print for anyone who thinks their printer could use a sleeping companion. :)   The supports are easiest to remove using pliers. Recommended Print Settings: Layer Height: 0.08 mm (for even better quality print with a 0.2 Nozzle and lower Layer Height) Wall Loops: 2 Infill: 15 %(Gyroid). Supports: Tree/organic supports Line width:default: 0.7 mm outer wall 0.7 mm top surface: 0.7 mm Seam position: Back Precise Wall: true Wall generator: Arachne Raft layers: 3 Initial layer expansion: 10 mm Top interface layers: 3 Top interface spacing: 0.15 mm Branch distance: 1 mm