Autumn Leaf Monitor Dragon (Desk Buddy)

Meet your new little Autumn Leaf Monitor Dragon  Designed to perch on top of your monitor or a shelf, this tiny desk buddy brings a bit of fall magic to your workspace, complete with leafy details and an oak-leaf tail.   Filament used Maple Forest (Matte) Multi color: https://www.amazon.com/dp/B0CZ43KVF7?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1   Printing Use a clean print plate with some glue (unless you are using a super tack plate) Use dried out filament(Different filament types impact the print differently, please adjust your settings accordingly.   Support Removal: Let the model cool down before removing the supports. Use pliers when removing the supports. Start with removing the support around the top, gently twisting to the side, do not pull downwards. I have tried to adjust the support settings for minimal impact, but different filament can impact how hard it attaches so some sanding might be needed. Light sanding and gentle, controlled heat may be needed to clean up areas where the supports were attached on the backside. I used a handheld mini torch, but apply heat carefully to avoid warping or damaging the print.   If you like this design, please leave a rating, a comment or a boost. Boost Me🍂 Oak-ay… I’ll admit it. I want your Boost. No worries if you can't boost, a rating or a comment is very much appreciated as well! 💛