Sunflower Petal Spinner (Spinning Flower Fidget)

This one was a lot of fun to make & it's my wife's new favorite! I spent more time, than I care to admit, making sure thbe petals stopped where I wanted them (to make it look like a sunflower as much as possible).   Notes: ASSEMBLY(Petals are numbered, install them in ascending order 1-6) Alternate 180° as you place each petal (number facing down) through the top pole of the stem:#1: leaves (3, the 1st one should have the wedge hole alligned with the ) #2-4: decreasing size of petals (3 each) #5: 2 of the smallest petals #6: top, smallest petal (standalone, does not have a peg) If done correctly, each tiny peg will sit in a wedge hole of the next petal/piece Push the disc firmly onto the stem (I recommend using CA glue, once you are satisifed with the result) The peg is a separate object, with a hole, & a different wall count (to maximize strength) Different surface layer patterns are used to make things look interesting Stem prints flat & has 5 walls, to maximize strengthWhile not technically necessary, I like to use supports for the wedge