Wind Up Outboard Center Console Boat MH010

Pool Party! Pull up to the pool with these awesome wind-up boats! Styled to look like the center console boats you see cruising offshore to go fish or to just pull up to the sand bar and Party!   About the design I went for a center console look. The boat features a helm with steering wheel, there are studs that can hold a mini figure and a seat on the front for one to sit. 2 side rails hold the top to the hull of the boat. The T top has hole for antennas and hole to hold “fishing poles” there is also a radar on the top. Towards the stern there are more studs for figures and the extended transom for the outboard.    While not necessary you can play with it as is, but I like things that move so I used the Maker supply kit MH101 to propel these little guys you can get yours here: Boat Kit Collection | Bambu Lab US Store   Assembly is simple! The 2 rails hold the top, Note: the rails tend to have a flat spot due to the way they are printed, you can sand or carefully use an exacto or similar tool to make it more round. After fitting them you can place them into the boat hull and add a drop of glue.  Next press in the steering wheel. Next add glue and press the side rails into the T top. Next glue on the radar to the T top.  For the antennas and rods I used cut pieces of filament you may need to clean the hole depending on how tight of a tolerance your printer can hold.  Any questions feel free to send me a message, I hope you like it and HAVE FUN!!!!