Clip On Towel Hanger

🧼 Clip-On Towel Hanger A clean, simple way to keep your kitchen towel exactly where you want it — no drilling, no hardware, no fuss. This clip-on bar slips right over the top edge of a standard cabinet or drawer face, giving you an instant towel hanger that looks intentional and stays put. 🔍 Overview Instant install — just slide it onto the cabinet edge and you’re done. Secure hold — keeps your towel accessible without slipping or bunching. Print-friendly design — optimized for strength, simplicity, and minimal supports. Customizable width — scale in the X direction to fit wider towels or cabinet faces. 🧵 Filament Recommendations PLA — totally fine for everyday kitchen use. PETG — ideal if you want extra durability or expect heavier towels. 🛠️ Assembly & Printing Three-piece barPrints flat for clean edges and strong layer adhesion. Slips together easily after printing, CA glue is recommended Support-light modelNearly zero supports needed — fast, clean prints. Scalable designWant a wider bar? Just stretch the model in X inside your slicer. No redesign required. 💡 Why You’ll Love It Keeps towels off the counter and within reach. Looks sleek and intentional — not like a temporary hack. Prints fast, installs instantly, and works in almost any kitchen setup.