Floating book display Stand (parametric)

A minimalist bracket that hooks over the edge of a shelf and showcases your favourite books!  No screws, no glue, no visible hardware — it just hangs on the plank and the weight of the book keeps everything in place.   The whole model is fully parametric, so you can fully adjust it to your own setup. Three things you can adjust: Book width – how thick of a book the stand holds Plank width – the thickness of your shelf, so the hook sits snug (add 1-2mm extra so it will not be too difficult to slide the stand over the plank) Hanger width – how wide the bracket itself is I have also uploaded the Fusion 360 file so you can also change these parameters in fusion 360   Out of the box the plank width is set for the IKEA Billy shelf, with a book thickness of 40mm.    Two versions included: Single piece – one continuous stand, maximum stability Double hanger – two separate brackets that sit under the book. Same job, but noticeably less print time and filament since there's no material in between.  I have printed the models in PLA and PLA tough+ which both were more than strong enough