Modular Rotating Desk Organizer

A fully 3D-printed modular tool organizer built around a rotating six-panel design. Mix and match SKÅDIS-compatible panels, tool modules, drawers, bins, and more to build an organizer around the tools you actually use. The compact six-sided design keeps everything within reach, while the rotating base provides easy access from every side.   Note: Some SKÅDIS-compatible accessories shown in the photos are third-party designs used to demonstrate compatibility and are not included with this model. Full creator credits and links are provided at the bottom of the description. Key Features Six interchangeable panel positions SKÅDIS-compatible panels Single & Duo Frame Panels Angled Tool Module Drawer & Bin Modules 360° rotating base Removable divided top tray 100% 3D printed. No purchased hardware or glue required* *The recommended configuration requires no glue, magnets, or purchased hardware. CA glue is recommended for the optional TPU feet. Magnets and CA glue are only required for the alternative Magnetic Top Rim &  Magnetic Top Tray. Recommended Configuration If you're not sure where to start, use one of the RecommendedConfig 3MF files. It's the setup depicted in my photos and the configuration used in the assembly instructions further down. Or create your own setup using the provided STLs! Just keep the following configuration limitations in mind:   Configuration Limitations   Angled Tool Modules: Install into Single Frame Panels. Up to 3 may be used. Each occupied Single Frame Panel must be separated from the next by at least one SKÅDIS or Pegboard Panel. When using 3 Angled Tool Modules, Drawer/Bin Modules cannot be used.   1 Drawer/Bin Module: Installs into a Duo Frame Panel. Up to 2 Angled Tool Modules may also be used, each installed in its own Single Frame Panel. The Duo Frame Panel and each Single Frame Panel containing a module must be separated by at least one SKÅDIS or Pegboard Panel.   2 Drawer/Bin Modules: Install into Duo Frame Panels. The two Duo Frame Panels must be positioned opposite one another. When using two Drawer/Bin Modules, Angled Tool Modules cannot be used.   SKÅDIS & Pegboard Panels: No special restrictions. Use all six, mix and match them, or combine them with Frame Panels as desired. Make It Your Own Looking for more options? OptionsAndAlternatives 3mfs include additional panels and components so you can customize the organizer beyond the Recommended Configuration. Magnetic Top Rim & Tray: The optional magnetic configuration uses up to 24 | 5×2mm round magnets and 6 | 15×2mm round magnets. Must glue.    A Custom Panel Template is also included with the STLs, giving you a starting point to design your own compatible panels and accessories.   Assembly Instructions     That's it! Your organizer is ready to load up and customize. Credits The following third-party SKÅDIS-compatible accessories are shown in the photos and are not included with this model. Huge thanks to their creators for sharing their designs! IKEA SKADIS Pliers Holder – 1 to 6 Slots V1.0 - MaxLayers Holder for Tweezers on a Skadis Board - Karel J. IKEA SKADIS Gorilla Glue Gel Holder (Upside Down) - IHaveBabyArms