*NEW!* Kanto Gym Badge Display & Frame V2

“The background has changed in size to allow for the new frame, the badge stand and badges are exactly the same as V1”   🔵 Background (200x230mm) 🔴 This Hueforge uses Bambu PLA Basic filament, other brands may not give the same results! 🟡 Print at 100% infill with a layer height of 0.08mm and a base layer of 0.16mm 🎨 2 Colour Print   Start with Black At layer #15 (1.28mm) swap to Jade White for the rest.     🔵 Badge Stand (170x100mm) 🔴 This Hueforge uses Bambu PLA Basic filament, other brands may not give the same results! 🟡 This one is only a Hueforge for the top few layers which will print at 100% infill with a layer height of 0.08mm and a base layer of 0.16mm. I have added a modifier so the beginning will print at 15% infill with a layer height of 0.2mm which saves a ton of time and filament. 🎨 2 Colour Print   Start with Black At layer #65 (11.36mm) swap to Jade White for the rest.     🔵 Badges   🔴 5x3 Magnets or Superglue to hold the badges into the stand. 🎨 12 Colour Print (for all 8 badges)   Black, Cyan, Hot Pink, Sunflower Yellow, Jade White, Gray, Pumpkin Orange, Red, BambuLab Green, Matte Grass Green & Brown     The Rainbow Badge has been separated for printing the 8 colours, please do take care when putting the colours into the badge.   Make sure you put each one in about half a millimetre and make sure they all fit in each of the holes before press fitting them all the way.   Each colour prints slightly different so please be careful when building this badge. Hopefully this will avoid having to print multiple badges.