Parametric Cross-Stitch Grid — Stand & Keychain

No fabric needed — a customizable display frame you cross-stitch directly on the printed plate. This model is fully parametric. In the Bambu Studio / MakerWorld Customizer, you can change the size, shape, and stitch count before printing. From palm-sized pieces up to about 25 cm, adjusting it freely to fit your chart is what makes it special. The stitching surface (the plate) is a cross-stitch hole grid, so you embroider straight onto it instead of using Aida fabric. When you're done, drop the plate into the frame and snap on the back cover — no glue needed. The back cover hides the stitched back so you can display the finished piece as-is. Stand it up with the easel stand, or hang it from the keychain loop.   ■ 3–4 parts (each printed separately) Frame: the decorative bezel. Square / rectangle, or cloud (scalloped) Stitch plate: a grid of square holes you stitch directly on Back cover: a flat lid that hides the stitched back; pegs drop into the frame's holes and lock with a barb Easel stand (optional): a stand for displaying it upright ■ Choosing size & stitch count (Customizer) Shape: square / rectangle / cloud (scalloped) Two ways to set size:By mm: 30–250 mm (up to about 25 cm) By stitch count: 4–66 cells each for width and height Keychain loop: on/off, hole diameter 3–8 mm Easel stand: on/off Guide: The default is about 70 mm square ≈ 28 × 28 cells. The maximum by stitch count is 66 × 66 cells ≈ 15 cm; by mm you can go up to 25 cm. Hole pitch is 2.10 mm (≈ 12-count). ■ Features No fabric — stitch directly on the printed plate Fully parametric — freely change size, shape, and stitch count in the Customizer Square, rectangular, and cloud (scalloped) shapes supported Two sizing methods — by mm, or by stitch count Glue-free snap-fit — just press the back cover on; open it anytime to take the piece out To open it, slide a scraper (or a thin flat tool) into the groove and gently pry the back cover off Optional keychain loop and easel stand Clean-printing design — every dimension is an integer multiple of the 0.42 mm line width, so walls stay crisp Print-layout mode places all parts flat, side by side, to print together ■ Recommended print settings Nozzle: 0.4 mm Line width: 0.42 mm (set first layer and inner walls to 0.42 as well) First layer speed: 10 mm/s recommended Layer height: 0.20 mm Infill: 15–20% Supports: None Material: PLA Orientation: print the plate hole-side up The grid holes keep two bridge lines (0.84 mm), so they print cleanly with a 0.4 mm nozzle.