wet filament test (know when to dry)

  WARNING This is an open experiment.   I have so far tested it with only bambu labs PLA and similar PLA’s (e.g. Tough,Silk+). Please feel free to help me out on this project by uploading remixes that work for other filament types.     How to use and Rough dry scale  look out for these features. The notability represents the dryness this is the rough scale for if the listed features  are noticeable:   foaming over bumps 45-50%  uneven stick diameter 55%-60% foaming at seam 60-65% a defined line/angle between bumps and stick 70%+ mostly even bumps 75-80%, bumpy upper stick 75-80%,  smooth upper stick 90%+ If it comes out perfectly the filament is bone dry You should try keep your filament at a minimum  75% dry, trust me it make a huge quality difference.     The goal To have a cheap simple quick way of knowing when to dry filament to avoid unnecessary drying/over-drying damage and know current filament quality with versions for every filament type     Click here to see one that works for tpu and other highly hygroscopic filaments: https://makerworld.com/en/models/2019450-filament-dryness-test      (The photo does use the same print the grey one broke at the base and is tilted)                                                                      (pla silk/silk+ will have worse overhangs)                                                                                      Boost Mejust in case