Fullrange desktop speakers

Compact Desktop Speakers Bring high-end sound to your desk! These compact 3D-printed speakers are designed around the Tang Band W3-2141 3-inch full-range driver, offering crystal-clear sound, detailed mids, and surprisingly rich bass in a small package. Whether you're working, gaming, or listening to music, this setup elevates your desktop audio without taking up valuable space. Boost MeKey Features Designed for Tang Band W3-2141: Tailored enclosure to get the maximum performance out of this 3" driver. Front Bass Ports: Dual front-facing ports deliver deep bass even if the speakers are placed close to a wall. Compact & Clean: Perfect minimalist design for any modern desk setup. Easy to Print: Optimized geometry for straightforward printing. What You Need (BOM) 2× Tang Band W3-2141 drivers 8× M3 screws (for driver mounting) Speaker cable & amplifier of your choice Polyfill or dampening material of your choice. Speaker sealing tape Assembly Guide Prep the Printed Enclosure: Clean up any stray stringing and ensure the mounting holes and port tubes are clear of debris. Add Sound Damping (Crucial for Bass!): Fill the inside of the cabinet with polyfill or acoustic stuffing. Not too loose, not too tight. This drops the tuning frequency from 85 Hz down to 76 Hz and cleans up unwanted resonances. Wire & Mount the Driver: Solder or attach your speaker wires to the Tang Band W3-2141 terminals, run the wire out through the rear holes, and secure the driver using M3 screws. Use a speaker sealing tape. Seal & Isolate: Ensure all wire exits/terminals are airtight (you can wrap the wires in painters tape) so air only moves through the front ports. 💡 Tip: Stick small rubber feet on the bottom to isolate vibrations from your desk!