Patron Tequila Display Box

Patron Tequila Folding door display box. Time for a tequila box. And what better way to start then with the Patron!!  If you're looking for small fast one hour prints, this isn't for you! This is a BIG one. I went with the traditional green and gold color for my version. I added some limited edition artwork on the sides to make it stand out from all angles. And of course there is some bees here an there. 😊 With the Led Lamp Kit 001 in the base and KC007 lighting up the bottle from above, this box really makes for a great addition to your Homebar or Mancave.   If Tequila ain't your thing, check out my other models. Maybe there is a box that fit's your taste buds.    Features LED Compatible: Includes a base specifically for the LED Lamp Kit 001 to give your bottle a golden glow.                                 It also has a cutout in the top (ø65mm) to fit an LED to light up the bottle from above. Magnetic Snap: Use 8x2mm magnets to provide a satisfying, secure "click" when closing the doors. Assembly guide : Follow the detailed assembly guide below. Internal dimensions: 125x125x270mm  Technical Specifications : ComponentQuantityNotesBase1Standard or LED-compatibleTop1LED-campatiblePins2For parts 31 and 32Back Parts15 Door Parts30 Hardware Required Steel Rods: 2 pcs (ø6mm x 300mm long) Magnets: 30 pcs Round 8x2mm (Required for door closure) Max strength N35 Adhesive: CA Glue (Superglue) for magnets and final assembly. Lighting: Optional LED Lamp Kit 001 / KC007 or similar Filament : I used Bambu labs filament for this project.   Want it to look exactly like the photos? Use these filaments :  Bambu Lab PLA Basic Mistletoe green  Bambu Lab  PLA silk + Gold  Bambu Lab PLA Matte charcoal (For the inside)   Assembly Tips Alignment: Ensure your steel rods are clean and straight for the smoothest door rotation. Supports :  Make sure all the supports are removed before assembly. Magnets : Be sure to orient the polarity of the magnets under assembly. Rod length : Before gluing the top on, double check that the rods aren't to long. Tolerance : Printers and filaments can behave differently. In rare cases, the holes can be a bit to tight because of settings.   If this happens, i recommend using a drill with a 6mm drill bit. Just run it through the hole a few times and you should be fine.    You can find the steel rods you need here  →   (affiliate link) If Bambu i out of stock, Led lamp kit 001 alternative → (affiliate link) If Bambu i out of stock, KC007 alternative → (affiliate link) 8X2mm Magnets → (affiliate link)    One's you have printed all the parts and acquired the accessories you need, just follow the assembly guide down below. Each individual part is marked with a number, making it very easy to assemble.     When your done, it should look something like this.