Pumpkin Can Sleeve

Boost MeIf you love this design, please consider boosting and rating! Thank you for your support.Please don't use the print profile with the AI image. That profile has not been tested and simply increases the layer height, which is something any user can do. This person adds print profiles with AI images and minor speed adjustments to siphon downloads and points. Please support the creator who has spent many hours and a lot of filament testing this design to provide you with the best quality. Thank you!   Personal use only. This version has my watermark. For the version without the watermark, it must be purchased on my website.   ✨ No AMS needed! All sizes included. - 12oz standard soda can & 16oz - 12oz slim, 8.4oz slim, 7.5oz mini, and 8.4oz Alani   There are 2 different size pumpkins. The Slim size is smaller than the Standard.   The slim size pumpkin (holding in listing photo) has 4 inserts for 12oz slim, 8.4oz slim, 7.5oz mini, and 8.4oz Alani cans. The larger size has inserts for 12oz standard and 16oz cans. All insert sizes are labeled in the 3MF and each STL is labeled. Please make sure you print the correct size. I simply write the size on the bottom of the printed insert with a silver sharpie.  By request, I have added a version without eyelashes. This version uses the same face as the top, but I do have plans to add different faces.  Support Removal: I do not recommend trying to pull the supports out from the front with pliers.  It is easier to push the supports through. I personally use a pick and a small hammer and tap the supports through. It does not require a lot of force or effort.  If you are using the version with eyelashes, it is a bit more difficult to remove suppports. I use and x-acto knife to get the supports out from between the eyelashes.  Make sure to remove supports from behind the eyelashes on the inside or the insert will not go all the way in. Important: This design requires the use of supports and requires you to know how to tweak your support settings for the cleanest print. I do not offer support outside of errors with the file. This file has been test printed a lot and is fully functional and without errors.    if you get stringing, adjust your supports or research the best settings for your printer and filament. I use Bambu Basic PLA Pumpkin Orange and Basic PLA Black for this design. I have not tested with Matte filaments. This could cause the insert to be harder to insert and remove.