Peacock Feather Bookmark or Decor

Bring a little bit of nature’s vibrant palette your current read - Peacock Feather 🌿🦚Or use it as a decor.   Pictures shown are printed in an 0.2mm Nozzle Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used:     PLA BambuLab Basic Black  Transmission Distance: 0.6     PLA BambuLab Basic Cyan  Transmission Distance: 1.8     PLA BambuLab Basic Yellow  Transmission Distance: 6     PLA BambuLab Basic Red  Transmission Distance: 4 This print uses 4 unique filaments Swap Instructions:     Start with Black     At layer (0.96mm) swap to Cyan     At layer (1.12mm) swap to Yellow     At layer (1.28mm) swap to Red     At layer (1.52mm) swap to Yellow for the rest.   Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away.