NASA Fabric: Soccer Ball (No AMS Needed)

Boost MePlease Boost if you like my model!Commercial License - https://www.patreon.com/c/measureonce/home NASA Fabric Collection - https://makerworld.com/en/collections/17685211-nasa-fabric-models  PLEASE READ! Important Notes: CLEAN YOUR BUILDPLATE AND USE GLUE BEFORE PRINTING! LAYER ADHESION IS VERY VERY IMPORTANT  USE PLA MATTE or PLA BASIC. This model has not been tested with silk filaments. I do not recommend using them due to the potential for over extrusion which can cause the layers to fuse If you are using the NO AMS Version, Please use a layer height of 0.16mm. Do not change this value. If it does get changed, the color swaps will not be applied to the appropriate layer and the part will come out looking off.  You will need to glue the magnets into their holes.  --------------------------------------------------------------------------------------------------------------------------------------------------------------------   This model uses 142 4x2 magnets.    Maker's Supply Store - https://us.store.bambulab.com/products/round-magnet?id=42102911074440 Amazon Link - 400 magnets for $20 - https://www.amazon.com/dp/B0F4MYLY85 Print Settings: Filament: Only PLA matte or PLA basic Layer height: 0.16 Walls: 4 Wall Generator: Arachne    Color Swaps for No AMS Version: WARNING!! LAYERS CORRESPOND TO A LAYER HEIGHT OF 0.16. IF YOU CHANGE THE LAYER HEIGHT THEN THE COLORS WILL BE PLACED IN INCORRECT POSITIONS.    Start: White Layer 52: Black Layer 56: White   Magnet Assembly  I have specifically put notches at the 12 and 6 o'clock position to signify a different polarity for the magnets (See 1st picture below).  In the 2nd image below you will see arrows pointing to all the locations where the magnet hole has the notch indicating a different polarity . All of the holes on the black pentagons have the notch.  You will need to glue the magnets into the pockets