Party Cup & Utensil Caddy V2 – Napkins, Straws

Everything for the party table in one print. Now with napkins and straws. 🎉   The original version was a hit, and the feedback was loud and clear "add napkins" and "add straws." So here's V2 same proven cup and utensil layout, two new compartments, and a Sharpie holder that's easier to see.   This started as a fix for our cabin, where every counter had a dozen plastic cups full of random forks and nobody could remember which drink was theirs. Now it all lives in one place.   What's inside: 🥤 Cup dispenser — sized for the big 18oz Costco/Kirkland red cups (100mm ID). Standard 16oz Solo cups drop right in too. Dual grab scallops make pulling a cup off the stack effortless 🍴 Three labeled bins — FORKS / KNIVES / SPOONS, engraved (no filament swap, no paint) 🧻 NEW: Napkin slot — deep enough that a gust won't scatter your stack, with a grab notch so you can pinch one out 🥤 NEW: Straw holder — dedicated silo, holds a dozen-plus standard straws ✍️ Sharpie holder — now on the front — so nobody drinks grandma's gin by mistake Print details: Bambu Lab P1S, matte black PLA — rotate 45° on the plate (it's a long part, this is required on a 256mm bed) No supports. Single piece, prints flat on the base 2 walls / 10-15% infill is plenty. PETG if it lives outdoors in the sun Perfect for tailgates, BBQs, cabins, beach houses, campers, graduation parties, and the garage fridge.     Boost MeCan I get a cookie for my time?