Count Binface

Count Binface,   I normally resist political posts and opinions, but how could I ignore this pivital point in British History when the one and only Bin face emerges as the only true contender to finaly wipe the smile off of a smug pure establishment figure. NO AMS REQUIRED!   A cute binface to stand on your desk or shelf while you bask in his “binificance” and magnificance. A true peoples hero in a bin! Standing at around 15cm tall, hes not too big and not too small but a perfect desk companion!   📌 Recommended printing settings: Material: PLA Layer height: 0.16 mm Infill: 15% Nozzle: 0.4mm supports where nessesary - I have tried to make it so all have a surface contacting the plate however due to the detail and complexity of the modeling they sometimes require alot of support, so be aware and be carefull during support removal. Use a naked flame gentley and for short intervals to clean surfaces after removal   Assembly – Recommended Method on multipart models Dry fit: Assemble all parts without glue to check alignment and fit. Cleanup: Lightly deburr edges and pegs where nessesary with a file/modeling tool to ensure uniform contact. All parts are tested and fit together. Optional fix: Use glue for permanent assembly.