Goku and Shenlong DragonBall Hueforge

Project: Goku and Shenlong in the Storm.hfp Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 156x234mm in size You may print at higher layer heights below the Base Thickness of 0.64mm The Max allowed Thickness is 2.88mm and the Actual Thickness is 2.88mm     #000000 PLA BambuLab Basic Black  Transmission Distance: 0.1     #9d432c PLA BambuLab Basic Brown  Transmission Distance: 2     #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5.8     #c00d1e PLA BambuLab Basic Red  Transmission Distance: 3.7     #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 5.2     #00ae42 PLA BambuLab Basic BambuLab Green  Transmission Distance: 2.6     #0086d6 PLA BambuLab Basic Cyan  Transmission Distance: 2.4 This print uses 7 unique filaments Swap Instructions:     Start with Black     At layer #8 (0.72mm) swap to Brown     At layer #11 (0.96mm) swap to Jade White     At layer #12 (1.04mm) swap to Red     At layer #16 (1.36mm) swap to Yellow     At layer #18 (1.52mm) swap to Jade White     At layer #20 (1.68mm) swap to Black     At layer #21 (1.76mm) swap to BambuLab Green     At layer #24 (2mm) swap to Yellow     At layer #25 (2.08mm) swap to Jade White     At layer #26 (2.16mm) swap to Cyan     At layer #29 (2.4mm) swap to Jade White for the rest.   For single AMS users, start with 4 colors as follows, Slot1: Black Slot2: Brown Slot3: White Slot4: Red 1st pause was set at Layer 13 to allow color swap: Slot2: Brown --> Yellow 2nd pause was set at Layer 17 to allow color swap: Slot4: Red --> Green 3rd pause was set at Layer 22 to allow color swap: Slot1: Black --> Cyan