NASA Fabric: Football (No AMS Needed)

Boost MePlease Boost if you like my modelPLEASE READ! Important Notes: CLEAN YOUR BUILDPLATE AND USE GLUE BEFORE PRINTING! LAYER ADHESION IS VERY VERY IMPORTANT  USE PLA MATTE or PLA BASIC. This model has not been tested with silk filaments. I do not recommend using them due to the potential for over extrusion which can cause the layers to fuse Use a layer height of 0.16mm. Do not change this value. If it does get changed, the color swaps will not be applied to the appropriate layer and the part will come out looking off.  --------------------------------------------------------------------------------------------------------------------------------------------------------------------   This model uses 62 4x2 magnets.    Maker's Supply Store - https://us.store.bambulab.com/products/round-magnet?id=42102911074440 Amazon Link - https://www.amazon.com/dp/B0F4MYLY85 Print Settings: Filament: Only PLA matte or PLA basic Layer height: 0.16 Walls: 4 Wall Generator: Arachne  Top layer pattern: Hilbert Curve   Color Swaps: WARNING!! LAYERS CORRESPOND TO A LAYER HEIGHT OF 0.16. IF YOU CHANGE THE LAYER HEIGHT THEN THE COLORS WILL BE PUT DOWN IN INCORRECT PLACES!!   Start: Black  Layer 55: Brown Layer 59: White   Magnet Assembly:   The magnets will need to be glued in. Start putting magnets of the same polarity on one side of each lobe. Work your way around clockwise. Once all the magnets with the same outward facing polarity are assembled, flip the magnets over and repeat.