The Impossible Twisty Cone - T2 Series

Note: The outer tips on this design are fragile, I'm still seeing if i can improve this further The Design   So here's my version of Ia Twisty Impossible Passthrough Cone. I've tried to make it as close as possible to my original passthrough cones.    This is the Start of the T2 Series, which will feature many of my previous designs reimagined into twisty versions.    This design is approximately 47mm Diameter and 80mm in height.    If you like this, let me know what other designs you'd like!   Let me know if you experience any issues.   Boost MeNever Needed, Always Appreciated!  Printing   Standard settings should work fine to slice   I've used Arachne to help with the inner sections, and i believe keeping arc fititng enabled helps too  The design may need a slight push to seperate the pieces after printing.    No supports needed.    The inner pieces are quite small, so need excellent bed adhesion - please made sure you clean your print plate with soapy water before attempting this   Once printed let the build plate cool before trying to remove. If you're having issues, let me know i will try and help.   My Work   Thank you to everyone who has and is supporting me in my design work, when my 8-5 engineering job ended a year ago i never expected to be able to design almost full time, and it's all thanks to you!   That said to stay full time i need your ongoing support with likes, downloads and boosts. Thank you again!     Want to sell prints?  If you want to sell prints of my designs, please join my Patreon:   https://www.patreon.com/RJ_Design   It includes more designs than i post here.   Alternatively you can join my Makerworld membership to sell prints of the designs i have on Makerworld  MembershipIf you want to sell prints of my designs, you need a commercial license :D